New bought Tinybee with Mini12864-V3.0 on a Cartesian type printer with TMC2225 drivers.
All steppers run normally with manual controls and also homing.
However, if running a gcode file, the extruder runs (x,y,z) to the starting point, but than only the y-, z-, and e- axis run with no movement on the x-axis. On a macro with many G1 x… y… z…lines all movements are OK.
The same happens with DRV8825 drivers.
The gcode made with Slic3r and also CuraEngine.
The Tinybee is programmed with the MKS-TinyBee-Main firmware, only adjusted to suit the V3.0 controller.