Ok, so it is weird because when I use the Creality slicer software and it scales the print down to a tiny obj and prints it in the top right corner, This has also happened with some other slicers. Then I do the 3D Printer OS slicer and it works perfectly fine. I am very confused.
This issue is likely caused by incorrect settings. If the slicer has incorrect build plate dimensions, it may scale the model down and place it in the wrong position (e.g., the top right corner). The slicer may be using an incorrect origin point,and check the scaling settings in the slicer to ensure the model is at 100% scale.
In addition, make sure your filament is of good quality and properly loaded, as issues with the filament can also affect the print quality.