Hi, I’m new to 3DPOS so maybe this is an easy one. I can’t seem to figure out how to change the filament feed rate on a print. I know the nozzel is not clogged but when the file starts printing it is just not pushing enough material. Where are the setting to change feed rate? thanks
You can look for settings like “extrusion multiplier,” “flow rate,” or “extrusion factor.” These terms are often used to control the amount of filament being extruded. Increasing these values will increase the amount of material being pushed out of the nozzle. It should be noted that different filaments indeed require different feed rates. The feed rate for PLA typically ranges between 40-60 mm/s, while the feed rate for PETG typically ranges between 50-60 mm/s.