Raspberry Pi 3 Manual Install Guide (while we are building image for it)

Raspberry Pi 3 Manual Install Guide

Any update on when the Raspberry 3 will be supported? (with an official image)

yes, here is unnamed image, you can download, and login it with your own credentials, and also change password
https://builds.3dprinteros.com/3DPrinterOS.zip
ssh login: root
aah pass: 3dprinteros
I suggest to update the cloud client to the latest from here: https://builds.3dprinteros.com/master/raspberry/5.9.8/3DPrinterOS-Client-5.9.8-build-193.zip

RPi generator used in cloud.3dprinteos.com update is scheduled to this Wednesday, then it will be possible to generate as usually RPi 3 image.

Hello,

Is this the log in after the boot with the flashed image? My input reads “3dprinteros-b827ebed2d2b login:” and isnt taking my credentials for 3dprinterOS

Hello. Where do you see those input? Do you have monitor connected?

If you have monitor connected and use our generic image (GENERIC RASPBERRY PI IMAGE on https://cloud.3dprinteros.com/download page) then you need to use default login&password (ssh login: root, ssh pass: 3dprinteros)

If you have monitor connected and use our prepared image (REQUEST RASPBERRY PI IMAGE on https://cloud.3dprinteros.com/download page) then you need to use login&password that were send in email with link to RPI image you download. But if you use that variant then you don’t need to login, it will work anyway. Image is already connected with your 3dprinteros account and had latest client release. So you don’t need to use monitor in that case. Just RPI and printer.