I found 3DprinterOS about a month ago and was amazed by the project. I got it up and running on a Raspberry Pi 2 within minutes! Amazing!
I did 1 print, with subpar results. My hypothesis was I didn't slice the model correctly. I changed my slicing and printed again, but the printer would not pull filament.
Instead it seemed like the filament feed servo was jittering, back and forth multiple times a second. I did some research and it seemed to fall under the category of failed servo. I thought it was a strange coincidence, but proceeded to order a new server ($50?!?!?). Along with the servo malfunction, when I rebooted the machine, the audible chime would not stop. A strange constant beep would come from the machine until powered off. Otherwise the menu was responsive, so I just turned off the sounds...
I just received the replacement servo, and like I feared, the server still jitters back and forth. I am scared that the 3DPrinterOS has bricked my Replicator 2 and would like to know if this issue has been seen before, and if there are any work arounds.
Thank you in advance.