I have two Hyvision Cubicons, and they print well with 3DPrinterOS. They work with the Generic Marlin printer choice.
The first issue is that the build volume is wrong, how can I edit this? I need a build volume of; 239 x 190 x 200 mm as opposed to the; 200 x 200 x 100 mm that it has now. Files are printing on the side rather than the middle because of this, and I can't use the full height of my build volume either.
The other issue that I am having is that the Cubicons have a heated build chamber and 3DPrinterOS doesn't support this right now. I have been trying to put the GCode into the start section on the Expert settings panel however it always resets and removes the GCode whenever I try to save.
How can I fix these issues? Thanks.